Brother CS5055PRW - Attachment of Lower Shaft Assy

3 - 69
Feed and rotary module
Application of Assembly
Application
4 Attachment of Lower shaft assy
1. Insert the set collar 2 to the lower shaft assy. 1, and then tighten the 2
screws 1 temporarily.
*Key point
• Check that the cut surface 3 of the set collar 2 is the out
side.
• Fully tighten the screw 1 after performing "3-70 Attachment of
Bushing presser B"".
2. Set the lower shaft assy. 1 to the base plate assy.
1
Torque
0.78 – 1.18 N·m
1
2 31
1
Set Screw, Socket (CP)
M4X4