Brother CS5055PRW - Attachment of Feed Bar; Attachment of Spring

3 - 74
Feed and rotary module
Application of Assembly
12 Attachment of Feed bar
1. Insert the polyester slider 2 and the feed bar 3 into the shaft of the feed
arm A assy. 1, and then attach the retaining ring CS4.
*Key point
• Check that the vertical adjusting screw 4 engaged with the
groove of the vertical lever 5.
• Check that there should no gap between the retaining ring
CS4 and the feed bar 3.
Apply EPNOC AP (N) 0 to the feed shaft hole in
the feed bar.
Bead
XC8387***
Apply EPNOC AP (N) 0 to the feed arm A assy.
Bead
XC8387***
Apply EPNOC AP (N) 0 to the groove of the
vertical lever.
Small amount
XC8387***
3
Retaining ring CS4
2
1
4
5
13 Attachment of Spring
1. Attach the spring to the feed bar 1 and the base plate assy. 2.
S05
S05
1
2
S05
SPRING
XE1940***
15.2