BT Micro Owner’s Manual
170
In this case choose ‘Selected Calls on VoIP’.
Up to 50 codes each of 5 digits can be entered.
Enter a code (01-50). Enter the digits e.g. 00 for international
calls. Press Confirm. The option to fallback to a PSTN line is
automatically selected. If this is required press Exit to return to
the Index page. If fallback is not wanted for this code select
Fallback to PSTN line and return to the Index page.
LCR (Least Cost Routing)
To set up the feature you associate dialled digits (Input Codes)
with the lines over which calls should be routed and with
whatever network codes (Output codes) are necessary to route
the call.
In addition, you may choose to route the calls over different
lines at various times of the day for optimum call rates.
The feature can be turned on permanently or activated at
particular times.
Once the facility is activated, calls are automatically routed over
the selected lines, and the network code (Output Code) is
dialled automatically on the line before the telephone number.
Select ‘LCR’
Select ‘LCR On’
Up to 50 LCR rules may be defined (Index 01-50).
Enter an Index number (01-50)
Enter the input code and press confirm
In the ‘Input Code’ field you insert the relevant dialled digits (e.g.
‘00’ for International calls or ‘001’ for International calls to the
USA).
Enter the Output code (up to 9 digits) and press confirm.
In the Output Code field, you insert whatever digits you want to
be passed to the network. If no additional carrier access codes
are required then the Output Code should match the Input
Code.
Select ‘Preferred’ or ‘Exclusive’.
Select the line or lines the call is to sent on.
Preferred means that if the selected line is not available the call
will be sent over any available line without the output code. If
exclusive is selected the call will not be placed if the selected
lines are busy.
When Enabling or Disabling the LCR feature the new setting
does not take immediate affect. There can be a delay a of up to
1 minute for the setting to take affect.
LCR Timebands
You can programme the Least Cost Routing facility, to be
automatically turned on and off twice during a 24-hour period
enabling you to tailor your call charges through different service
providers.
Select Outgoing VoIP Calls
Select LCR
Select LCR Timebands
Select LCR on times
You can enter two 'On' times.
Select LCR off Times
You can enter two times at which the LCR facility is deactivated
A Third option 'LCR weekend' is offered. When this is selected
the LCR service remains active from Friday night to Monday
morning; all off times over the weekend are ignored.
To Next Page
Loading...
Need help?
General