MONITOR LS SET UP
The screen shows a representation of
the Monitor LS controls. The right side of
the screen lists all the available monitor
sources. Monitor sources are allocated
to the assignable selection buttons as
follows:
Select the button to which you want
•
to assign a source (screen button will
flash)
Select the required monitor soure
•
from the list
Select “Allocate”
•
For external sources, a pop up window
allows the user to enter a suitable label for
the screen button, and to choose whether
the source is mono, stereo or surround.
To clear any button of its assignment,
simply allocate “Blank” from the list as a
source.
If your console uses the assignable
monitor panels, their control screens will
be slightly different. Please refer to the
Assignable Monitor Panels section for
details of their set up.
Buttons can only be assigned when in
Technician or Supervisor mode. This
allows the system to be set up prior
to operation, and protects against
accidental changes once the console
is in use.
To Next Page
Loading...
