clear many channels at the same time. This
is implemented on the User-Chan screen
Buttons on the Options - Misc screen
set the functionality of the All A and All
B buttons on the assignable fader when
using a short press. If set to change layer,
a short press on the ALL A and ALL B
buttons will switch all the channel faders
to display either their A path or their B
path permanently. If set to “Latch View”, a
short press of an All A or All B button will
display the paths on the control surface
until the button is pressed again. This is so
that the console’s A/B display pattern is
not lost. The console will revert back to the
previously displayed layer on each fader.
Panels - Input/Output screen. A screen
representing the Input/Output panel
controls.
Panels - Route screen now includes track
send controls. Interrogation will not be
permitted from the screen.
Cue Director can now associate Hydra
input ports with external router inputs and
Hydra output ports with external router
outputs. It is still not possible to route
Hydra inputs to Hydra outputs.
Links to Operator Manual pdf in Calrec
group from Windows Start menu.
V2.3 Included:
Panels - Routing Matrix screen - Similar
to Spill-Routes screen, but includes all
channels, mains and auxes in addition. Spill
Routes screen will no longer exist.
For Surround CRLS and Meters 1-4
(Main 1 and Anc 1 on traditional style
monitor panels), TFT Meter width is now
dependent upon the source selected. The
TFT Meter will automatically change to
match the source.
Panels - Track Output screen.
Replay button and setup screen. Channels
selected by the replay screen will flip to
input 2 when the replay button and EXEC
is pressed. Memories will store replay
selections.
Divergence/Convergence on stereo
channels and groups. Also, divergence
changes such that the overall volume isn’t
increased when it is applied.
EQ on main outputs including HF filter to
go down to 50Hz (for use as LFE filter).
Expander on main outputs.
Spill out Surround Mains - so that the spill
panel can be used to control each leg of
the surround main.
Spill panel to be used to control downmix
levels from surround channels and groups
to stereo busses. Spare button on the
spill panel will be used to select the mode
of the panel. Also controls Main output
stereo downmix on surround Mains.
Thicker Peak spot/Phase marker on TFT
meters.
Longer time constant on peak spot on
TFT meters.
Delay on Main insert sends.
Optional LB and RB (Left to Both, Right
to Both) switching from the fader strip,
instead of DIR TB and ALT WILD.
V2.6 included:
Support for Ross Video Overdrive/
Synergy system via a serial interface.
V2.6B included:
Offline Editor functionality.
V2.6F included:
Default compressor attack time changed
from 5ms to 30ms.
V2.8 includes:
Up to 33 SDI boxes on a network.
To Next Page
Loading...
