9-14
Installing the Optional Accessories
9
Paper Feeder
1
Turn the printer OFF.
2
If a USB cable is connected, turn the computer off, and then
disconnect the USB cable from the printer.
3
Disconnect the power plug from the AC power outlet.
4
Remove the power cord from the printer.
5
If a LAN cable is connected, disconnect it from the network
board.
6
Pull out the paper cassettes from the printer and paper feeder.
7
Lift the printer unit and remove it from the paper feeder.
8
Move the paper feeder.
9
Move back the printer to the installation site.
10
Set the paper cassette in the printer.
11
Connect the LAN cable to the network board as needed.
12
Connect the power cord to the printer.
13
Plug the power plug into the AC power outlet.
14
Connect the USB cable to the printer as needed.
To Next Page
Loading...
