8-36
Paper Problems
Tr oubleshooting
8
Paper Problems
Paper comes out wrinkled.
Cause 1 Paper is not loaded properly in the paper cassette or multi-purpose tray.
Remedy
Load the paper properly in the paper cassette or multi-purpose tray. (
See
"Loading Paper in the Paper Cassette," on p. 3-17, "Loading Paper in the
Multi-purpose Tray," on p. 3-31)
Cause 2 Paper is damp due to being stored under unsuitable conditions.
Remedy Replace the paper with new paper in an unopened package. (See "Paper
Requirements," on p. 3-2)
Paper curls.
Cause 1 Paper is damp due to being stored under unsuitable conditions.
Remedy Replace the paper with new paper in an unopened package.
(See "Paper
Requirements," on p. 3-2)
Cause 2 Appropriate paper is not being used.
Remedy Replace the paper with that which can be used with this printer. (See "Paper
Requirements," on p. 3-2)
Cause 3 The paper is too thin.
Remedy Perform the following procedure in the printer driver.
1. Display the [Paper Source] sheet.
2. Set [Paper Type] to [Plain Paper L].
Cause 4 Paper that curls easily is output to the face-down output tray.
Remedy Switch to the face-up output slot when printing transparencies, labels, Index
Card, or envelopes which tend to curl. (See "Paper Requirements," on p. 3-2)
White dust is attached to the printed transparencies.
Cause If you print transparencies after printing paper other than transparency
continuously, chipped paper may attach to the transparencies when they
are output.
Remedy Wipe and remove the chipped paper with a soft cloth.
To Next Page
Loading...
