Canrig PC3000 - Drawing ID: 121300032 Rev No: C

1
4
7
6
5
2
3
ITEM PART NUMBER REV QTY/UNIT TYPE DESCRIPTION MATERIAL STOCK SIZE MANUFACTURER MANUFACTURER PART NO LENGTH PROCESS PROCESS 1 PROCESS 2 PROCESS 3 PROCESS 4 WEIGHT
1 H10365 B 1 PURCHASED CYL, KICKER, BORE 3.0, ROD 1.5, ST 6.0 - - RAM INDUSTRIES R4506376 0000 - - - - -
2 M10533 A 1 PURCHASED FTG, GREASE, 1/8" NPT, PTF-SS - - LINCOLN 5000 - 0000 0.0
3 M10668 B 1 PURCHASED GREASE NIPPLE, 1/8 NPT, 90 DEGREE - - LINCOLN 205400 - 0000 0.0
4 H15-070220-08-08 C 1 PURCHASED ELL 90°, MALE 1/2 JIC, MALE 1/2 ORB - - PARKER 8 C5OX-S - 0000 0.0
5 H15-070320-08-08 A 1 PURCHASED ELL 45°, MALE 1/2 JIC, MALE 1/2 ORB G40.21-44W - AEROQUIP 2061-8-8S - 0000 0.0
6 161100092 C 1 ROUND BAR PIN, .94 x 6.18 WL, KICKER ROUND BAR .94 x 7.5, C1045 STG (SEE NOTE) 15/16" - - 7 1/2" 0023 1.4
7 SH-0312NC-0150 B 1 HARDWARE CAPSCR, HEX SOC HD, 5/16-18UNC X 1.50 GR8 - - - - 0000 0.0
C 2012/10/16 OOT REVISED DRAWING 1619 GWL SH
B 2009/05/14
COMPONENTS WITHIN AY50373 WERE DISSOLVED INTO THIS
ASSEMBLY
1285
A 2008/6/16 UPDATED DRAWING FORMAT
REL-01 2007/10/31 RFM
REV DATE BY REVISION DESCRIPTION ECN CHKD APVD
REV: DATE:
121300032 07/10/31
ASSY, KICKER CYL DS FRONT
1 OF 1 C
DRAWING NO:
© 2010 CANRIG DRILLING TECHNOLOGY CANADA LIMITED
ALL RIGHTS RESERVED
SHEET:
TITLE:
THE DRAWINGS, INFORMATION AND SUBJECT MATTER HEREOF
ARE THE CONFIDENTIAL, SOLE AND EXCLUSIVE PROPERTY OF
CANRIG DRILLING TECHNOLOGY CANADA LTD, AND ARE NOT
TO BE COPIED, REPRODUCED, OR USED IN ANY MANNER FOR
ANY PURPOSE WHATSOEVER WITHOUT WRITTEN CONSENT
OR DIRECTION.
DRAWN BY:
JCR