Canrig PC3000 - Drawing ID: 121300072 (2 of 2) Rev No: B

INIT.
4 3 2 1
2 1
A B D
A B
SHEET SIZE
B
YY/MM/DD
SCALE
FLATNESS
± .010 or as Shown
FAB R ICA T IO N ± 2°M AC HIN IN G ± 1 °
± 13 mm7112 & OVER ± 7 mm3048 TO 7112 ± 5 mm1525 TO 3048
± .005"
± 1/2"280" & OVER ± 1/4" ± 3/16"
120" to 280" 60 to 120"
MIN. RADIUS UNLESS SHOWN = 0.03 MAX.
.x .xx
± 1 mm ± 3 mm
DECIMAL
0 TO 610 mm 610 TO 1525
E
FABRICATING [METRIC]FABRICATING IMPERIAL
± .030"
± 1/8" ± 1/16"
24" to 60" 0 to 24" MACHINING IMPERIAL
.xxx
± 1/16
.005 TIRCONCENTRICITY
SQUARENESS STRAIGHTNESS
CASTING
.005 125
TRUE POSITION PARALLELISM
MACHINED SURFACES
± .010 IN 5 INCHES
REMOVE SHARP CORNERS AND BURRS
TOLERANCE - UNLESS OTHERWISE SPECIFIED
± .005 IN 5 INCHES
± .010 IN 5 INCHES
IF IN DOUBT......PLEASE ASK!
IF IN DOUBT......PLEASE ASK!
WELDING PROCEDURE AS PER CANRIG SPECIFICATION - ENG 704, UNLESS NOTED OTHERWISE
REV
DRAWN APPROVED CHECKED
EST. WEIGHT
THIS PRINT AND DESIGN AND DETAIL SHOWN THEREON ARE THE PROPERTY AND INVENTION OF CANRIG DRILLING TECHNOLOGY LTD.. THIS PRINT IS FURNISHED WITH THE UNDERSTANDING THAT IT IS NOT TO BE REPRODUCED UPON DEM AND. ALL RIGHTS OF DESIGN AND INVENTION ARE RESERVED BY CANRIG DRILLING TECHNOLOGY LTD.. WITHOUT PERMISSION AND RETURNED
ANGULAR
± .8 mm
x.xx
± .40 mm ± .13 mm
DECIMAL x.
x.x± .015"
SHEET 2 OF 2
B
MACHINING METRIC
PC3000
1:4
121300072
TLK
OT GF
09/04/07 09/04/07 09/04/07
MODELED
TLK
09/04/07
THIRD ANGLE PROJECTION
ASSY, SKATE DRIVE, CARRIER,
DRAWING
317.8 lbs
4 3
E
D
DO NOT SCALE
MATERIAL
9
9 810 5 4
2
12 12 13
7
6
1
3
11
8 10