Maintanance, Service, and Troubleshooting
Canrig Drilling Technology Ltd. 6-11
• The recommended working temperature of the sump should be 122 – 158°F (50 to 70°C).
• The intermittent peak temperature of the sump should be no greater than 203°F (95°C).
• The winch is filled via the filler plug. Fill with gear oil until it reaches the oil level gauge/port. For more
information, please refer to the manufacturer’s literature.
Table 6-2: Oil Brands Recommended for Various Ambient Temperatures
Ambient Temperature °F (°C)
LANTEC–tested
Lubricant
14° to 59° F
(–10° to 15°C)
32° to 86°F
(0° to 30°C)
50° to 122°F
(10° to 50°C)
Spartan EP 220 Spartan EP 220 Meropa 150
Meropa
Exxon Products Spartan EP 100 Spartan EP 150 Spartan EP 220
Mobil Products
Mobilgear 627 Mobilgear 629 Mobilgear 630
NOTE: cSt is the same as mm
2
/s. For special conditions, consult Canrig for recommendations.
Warning!
. DO NOT OVERFILL. Overfilling may
cause the winch to overheat.
. Before you work under the raised
carrier, install the safety stop bar.
Caution
Do not operate or perform any lubrication, mainte-
nance, or repair on this product UNTIL you have
read and understood the operation, lubrication,
maintenance, and repair information.
To Next Page
Loading...