Chroma A620028 User Manual

Programmable DC Power Supply (with Solar Array Simulation) 62000H Series
Operating & Programming Manual
4-22
4.3.2 Setting IV-Sequence
1. The default number of IV-SEQUENCE(s) in an IV-PROGRAM is 0. Each IV-PROGRAM
can add up to 100 sequences. The maximum number of IV-SEQUENCE(s) set in the 10
IV-PROGRAMS is 1000.
2. To add a new IV-SEQUENCE:
a. In the IV-PROGRAM page (Figure 4-26), when the cursor is at (4), press “
”
to add the first IV-SEQUENCE if there is no IV-SEQUENCE in the IV-PROGRAM.
The screen will appear as shown in Figure 4-27.
b. In the IV-SEQUENCE page (Figure 4-27) under an IV-PROGRAM, when the cursor
is at (4), press “
” to add another new IV-SEQUENCE.
The “
” key is normally used as the direction key and is only used to
add new IV-SEQUENCE(s) in the above two conditions.
3. Use the “
”, “ ” keys to move the cursor to the column to be set as shown in
Figure 4-27.
Figure 4-27
4. Use the numeric keys
0
-
9
or the “Rotary” ( ) knob to set the value.
Each IV-Sequence can set the following 4 items: (1) SEQ NO., (2) IV-FILE NO., (3) SEQ.
TYPE and (4) TIME.
5. Press “ ” to confirm.
6. Press “ ” to return to IV-Program Page (Figure 4-26).
4.3.2.1 Setting Sequence Number
1. Use the “ ”, “ ” keys to move the cursor to the column to be set as shown in
Figure 4-27 (1).
2. When the cursor is at Figure 4-27 (4), press “ ” to add a new IV-SEQUENCE. The
numeric keys
0
-
9
or the “Rotary” ( ) knob can also be used to enter a
[
I V-
S E Q U E N C E ]
S E Q N O. =
1 _
I V –
F I L E N O. = 0
S E Q T Y P E = A U T O
T I M E =
0 ( S
)
▲
▼
( 1 )
( 2 )
(
4 )
( 3
)
ENTER
EXIT

Chroma A620028 Specifications

General

Brand	Chroma
Model	A620028
Category	Power Supply
Language	English