Remote Operation
STEP 9:
Select the “Basic I/O” tab and select the ‘Read’ tab to read back the 62000H status and click
Execute.
5.2 GPIB Function of 62000H Series
Table 5-4
Commands and response messages can be sent and received
over the GPIB bus. Status information can be read using a series
Sets the SRQ line to true if there is an enabled service request
condition.
When powered-on in local mode, the front panel is operational and
the commands are sent through the GPIB interface. When in
remote mode, all front panel keys are invalid except
.
will return the supply to local mode operation.
5.3 Introduction to Programming
All commands and response messages are transmitted in ASCII codes. The response
messages must be read completely before a new command is sent, or the remaining
response messages will be lost causing a query interrupt error.
To Next Page
Loading...
