Programmable DC Power Supply (with Solar Array Simulation) 62000H Series
Operating & Programming Manual
1. Keep all of the packing materials in case the device needs to be
returned for repair.
2. Do not return the instrument to the factory without obtaining prior
RMA approval from Chroma.
3. Verify all the accessories listed in the packing list were received.
The power supply is too heavy for one person to safely lift and mount. To
avoid injury, ask a co-worker for assistance.
2.1.1 Maintenance & Cleaning
Remove all connected wires and cables on the instrument before cleaning. Use a brush to
remove any dust on it and if there are stains on the chassis that cannot be removed by brush,
wipe it with a volatile liquid (such as Cleaning Naphtha). Do not use any corrosive liquid to
avoid damaging the chassis. Use a damp cloth with soapy water or soft detergent to clean the
LCD front panel. For internal cleaning, use a low-pressure air gun to remove the dust inside
or send it back to a Chroma agent for cleaning.
2.2 Preparation for Use
(1) Remove the iron holder on the front panel as shown in Figure 2-2 and keep it in case the
Power Supply needs to be returned for service.
(2) Be sure the Power Supply is connected to an AC line input that meets the specifications.
(3) The instrument must be installed in an area with good air circulation to avoid the internal
temperature getting too high.
(4) The ambient temperature should not exceed 40°C.
Figure 2-2
1. If the iron holder on the front panel is not removed, it may cause an
OTP error or damage to the hardware due to poor ventilation.
2. The 62020H-150S model does not have the holder.
To Next Page
Loading...
