Chroma A620028 - Page 17

xv
Revision History
The following lists the additions, deletions and modifications in this manual at each revision.
Date
Version
Revised Sections
May 2010
1.0
Complete this manual.
Aug. 2010
1.1
Modify the following sections to add new model 62150H-1000S and I-V
Curve Programming function:
– “Specifications” and “Other Specifications” as well as Notes in the
chapter of “Overview”
– “Specification of Parallel Capacitance “ in the chapter of
“Installation”
– “Setting Configuration “ and “SERIES/PARALLEL “ in the chapter
of “Manual Operation”
Add the following:
– Suggested O type terminal specification in the section of “Input
Connection” under “Installation”
– “SAS Subsystem” in the chapter of “Remote Operation”
Update the following:
– “TABLE MODE” and “SAS MODE” section in the chapter of
“Manual Operation”
– “IV Subsystem” in the chapter of “Remote Operation”
Apr. 2011
1.2
Add the following in the chapter of “Overview” & “Remote Operation”:
– Specification of model 62050H-600S
– Two reference figures in the “CAUTION” under Specification
– TRIG command to “SAS Subsystem”
Update the following in the chapter of “Overview”:
– Specification of 62150H-1000S
– The figure of front panel of 62000H with Solar Array Simulation
and main power switch
Nov. 2011
1.3
Add A620028 and A620027 SLAVE models in the manual.
Aug. 2012
1.4
Update the following:
− Description in “Specification” section
− Value of minimum output voltage in “Other Specifications” section
− Notice in “Checking the Package” section
− Notice in “SERIES/PARALLEL” section
− Notice in “Assembling Series/Parallel Communication Interface”
section
Add “D/D FAULT Protection” section in the chapter of “Manual
Operation”
Oct. 2013
1.5
Add the following functions (only applicable when the firmware is
upgraded to 2.00):
− “CURR. SHARING ERR Protection”, “FPGA UPDATE!
Protection”, “C/S CABLE ERR. Protection”, “MATCH Warning”,
“RS485 PARSER”, “EN50530 MODE” and “SANDIA_ MODE”
sections in the chapter of “Manual Operation”
− “EN50530 MODE” and “SANDIA_ MODE” description in the
section of “SAS Subsystem”
Jul. 2014
1.6
Add Model 62020H-150S along with its specifications and usage
descriptions in the manual.
Mar. 2015
1.7
Update the following:
− The figure of rear panel.
−
The output connecting cables diagram for Model 62020H-150S.