Circutor CVM-B100 - 5�6�5�- Measurement Connection Mode

5.6.5.- MEASUREMENT CONNECTION MODE.
This screen, Figure 119, is for selecting the measurement connection mode.
Figure 119: Measurement connection mode conguration screen.
The following options appear in the lower area:
Single-phase.
Two-phase.
Two-phase with neutral.
Three-phase.
Three-phase with neutral.
Aron.
Conrm, conrms and saves in the memory the value programmed on the screen.
Back, returns to the home screen of the setup menu Figure 114.
Main Menu, back to the main menu, Figure 25.
Use the keys
and to select the different options.
To conrm the selection, press the key
.
If no key is pressed for 5 minutes, the display screen changes automatically to the default
screen.
130
CVM-B100 - CVM-B150
Instruction Manual