Circutor CVM-B100 - 8.1.- UNIT SOFTWARE UPDATE.; 8.2.- EXPANSION MODULES UPDATE

8.1.- UNIT SOFTWARE UPDATE.
The update les depend on the model of the unit:
Table 163:Display software update les.
Model Display software update le
CVM-B100
rmware_cpu.bin
resources_CVM_B100.pbr
CVM-B150
rmware_cpu.bin
resources_CVM_B150.pbr
Follow the steps below to update the unit software:
1.- Copy the 2 les, Table 163, in the microSD card.
2.- Insert the microSD card in its slot.
3.- Connect the unit to the power supply.
The unit is automatically updated when started.
The updating process may take a few seconds and will be completed once the screen
application has started.
Note: If the expansion modules installed in the unit are not compatible with a new software
upgrade, a message will appear on the screen indicating that they need to be upgraded.
Once the unit has started, the le “rmware_cpu.bim” is deleted automatically from the microSD
card.
8.2.- EXPANSION MODULES UPDATE
The update les are:
Table 164:Expansion modules update le.
Model Expansion modules update le
Transistor digital inputs/outputs
Relay Digital Inputs/Outputs
rmware_digi.bin
Analogue Inputs/Outputs rmware_analog.bin
Modbus TCP (Bridge) communications rmware_modbus_ip.bin
Modbus TCP (Switch) communications rmware_mtcp_switch.bin
LonWorks communications rmware_lonworks.bin
Probus communications rmware_probus.bin
MBus communications rmware_mbus.bin
Datalogger rmware_embedded.bin
Follow the steps below to update the unit software:
1.- Replace the new le, Table 164, with the le in the microSD card.
2.- Insert the microSD card in its slot.
3.- Connect the unit to the power supply.
The unit scans the modules connected to it and looks to see whether there is a new update
for each of them.
If there is, the updating process may take around 7 minutes.
311
Instruction Manual
CVM-B100 - CVM-B150