Configuring L2VPN Global Parameters
Perform this task to configure L2VPN global parameters.
SUMMARY STEPS
1. configure
2. l2vpn
3. router-id router-id
4. pw-routing
5. global-id global-id
6. bgp
7. rd route-distinguisher
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3 router-id router-id
Example:
RP/0/RSP0/CPU0:router(config)# router 2.2.2.2
Specifies the router ID.
Step 4 pw-routing
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-routing
Enables pseudowire routing capabilities and enters the pseudowire routing configuration submode
Step 5 global-id global-id
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
94
Implementing Point to Point Layer 2 Services
Configuring L2VPN Global Parameters
To Next Page
Loading...
Need help?
General
