RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# global-id 1000
Configures the L2VPN global ID value for the router.
Step 6 bgp
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# bgp
Enables the BGP pseudowire routing capabilities and enters the BGP configuration submode.
Step 7 rd route-distinguisher
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwr-bgp)# rd 192.168.1.3:10
Configures the BGP route distinguisher.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring L2VPN VPWS SS-PW
Perform this task to configure L2VPN VPWS SS-PWs.
SUMMARY STEPS
1. configure
2. interface typeinterface-path-id
3. l2vpn
4. xconnect group group-name
5. p2p xconnect-name
6. interface type interface-path-id
7. neighbor routed global-id: prefix: ac-id source ac-id
8. (optional) pw-class class-name
9. Use the commit or end command.
DETAILED STEPS
Step 1 configure
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
95
Implementing Point to Point Layer 2 Services
Configuring L2VPN VPWS SS-PW
To Next Page
Loading...
Need help?
General
