Configuring the Source Address 297
Configuring PWHE Interface Parameters 298
Configuring PWHE Layer 2 Subinterfaces and Adding it to the Bridge-domain 301
Configuring PWHE Layer 3 Subinterfaces 304
Configuring L2VPN over GRE 306
Configuring a GRE Tunnel as Preferred Path for Pseudowire 312
Configuring VPLS LSM: Examples 313
Enabling P2MP PW with RSVP-TE on a VFI 313
Enabling BGP Autodiscover Signaling for P2MP PW on a VFI 315
Configuring VPN ID 317
Configuring IGMP Snooping 319
Configuration Examples for Multipoint Layer 2 Services 321
Multipoint Layer 2 Services Configuration for Provider Edge-to-Provider Edge: Example 321
Multipoint Layer 2 Services Configuration for Provider Edge-to-Customer Edge: Example 322
Displaying MAC Address Withdrawal Fields: Example 322
Split Horizon Group: Example 324
Blocking Unknown Unicast Flooding: Example 325
Disabling MAC Flush: Examples 326
Bridging on IOS XR Trunk Interfaces: Example 327
Bridging on Ethernet Flow Points: Example 331
Changing the Flood Optimization Mode 334
Configuring VPLS with BGP Autodiscovery and Signaling: Example 335
LDP and BGP Configuration 335
Minimum L2VPN Configuration for BGP Autodiscovery with BGP Signaling 336
VPLS with BGP Autodiscovery and BGP Signaling 336
Minimum Configuration for BGP Autodiscovery with LDP Signaling 338
VPLS with BGP Autodiscovery and LDP Signaling 338
VPLS with both BGP Autodiscovery and Manual Provisioning of VPLS Peers 340
Configuring Dynamic ARP Inspection: Example 340
Configuring IP Source Guard: Example 342
Configuring G.8032 Ethernet Ring Protection: Example 343
Configuring Interconnection Node: Example 344
Configuring the Node of an Open Ring: Example 345
Configuring Flow Aware Transport Pseudowire: Example 346
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
xiv
Contents
To Next Page
Loading...
Need help?
General
