Cisco A9K-SIP-700 Configuration Guidelines

Step 9 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet0/0/0/1.1
Specifies the interface type and instance.
Step 10 interworking ipv4
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4
Configures IPv4 interworking under P2P.
Step 11 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface Serial0/0/0/0/2/1/1:0
Specifies the interface type and instance.
Step 12 neighborA.B.C.Dpw-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface Serial0/0/0/0/2/1/1:0
Configures the pseudowire segment for the cross-connect.
Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix
Note
Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN
Step 13 pw-classclass-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface Serial0/0/0/0/2/1/1:0
Configures the pseudowire segment for the cross-connect.
Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix
Note
Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN
Step 14 pw-classclass-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# pw-class class_cem
Enters pseudowire class submode, allowing you to define a pseudowire class template.
Step 15 exit
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# exit
Exits the current configuration mode.
Step 16 interworking ipv4
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
139
Implementing Point to Point Layer 2 Services
Configuring IP Interworking between PPP and Ethernet

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English