Example:
RP/0/RSP0/CPU0:router# configure
Enters Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router (config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3 pw-class class-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn)# pw-class class_cem
Enters pseudowire class submode, allowing you to define a pseudowire class template.
Step 4 encapsulation mpls
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-pwc)# encapsulation mpls
Sets pseudowire encapsulation to MPLS.
Step 5 protocol ldp
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-pwc-encap-mpls)# protocol ldp
Sets pseudowire signaling protocol to LDP.
Step 6 end
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc-encap-mpls)# end
System prompts you to commit changes:
Uncommitted changes found, commit them before exiting(yes/no/cancel)?[cancel]:
• • Entering yes saves configuration changes to the running configuration file, exits the configuration session,
and returns the router to EXEC mode.
• Entering no exits the configuration session and returns the router to EXEC mode without committing the
configuration changes.
• Entering cancel leaves the router in the current configuration session without exiting or committing the
configuration changes.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
145
Implementing Point to Point Layer 2 Services
Associating a Pseudowire Class
To Next Page
Loading...
Need help?
General
