Step 7 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group grp_1
Configures a cross-connect group.
Step 8 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p vlan1
Configures a point-to-point cross-connect.
Step 9 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface CEM0/1/0/9:20
Specifies the interface type and instance.
Step 10 neighbor A.B.C.D pw-id pseudowire-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 10.2.2.2 pw-id 11
Configures the pseudowire segment for the cross-connect.
Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix.
Note
Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN.
Pseudowire status (pw-status) is enabled by default, use the pw-status disable command to disable pseudowire
status if required.
Note
Step 11 pw-class class-name
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# pw-class class_cem
Associates the P2P attachment circuit with the specified pseudowire class.
Step 12 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
146
Implementing Point to Point Layer 2 Services
Associating a Pseudowire Class
To Next Page
Loading...
Need help?
General
