Enters interface configuration mode. Changes configuration mode to act on GigabitEthernet0/6/0/5.
Step 6 bundle id 10 mode active
Establishes GigabitEthernet0/6/0/5 as a member of Bundle-ether10. The mode active keywords specify LACP protocol.
Step 7 interface GigabitEthernet0/6/0/6
Enters interface configuration mode. Changes configuration mode to act on GigabitEthernet0/6/0/6.
Step 8 bundle id 10 mode active
Establishes GigabitEthernet0/6/0/6 as a member of Bundle-ether10. The mode active keywords specify LACP protocol.
Step 9 interface GigabitEthernet0/6/0/7.999 l2transport
Creates an EFP under GigabitEthernet0/6/0/7.
Step 10 encapsulation dot1q 999
Assigns VLAN ID of 999 to this EFP.
Step 11 interface TenGigE0/1/0/2.999 l2transport
Creates an EFP under TenGigE0/1/0/2.
Step 12 encapsulation dot1q 999
Assigns VLAN ID of 999 to this EFP.
Step 13 l2vpn
Enters L2VPN configuration mode.
Step 14 bridge group examples
Creates the bridge group named examples.
Step 15 bridge-domain test-efp
Creates the bridge domain named test-efp, that is a member of bridge group examples.
Step 16 interface Bundle-ether10.999
Establishes Bundle-ether10.999 as an AC of the bridge domain named test-efp.
Step 17 exit
Exits bridge domain AC configuration submode, allowing next AC to be configured.
Step 18 interface GigabitEthernet0/6/0/7.999
Establishes GigabitEthernet0/6/0/7.999 as an AC of the bridge domain named test-efp.
Step 19 exit
Exits bridge domain AC configuration submode, allowing next AC to be configured.
Step 20 interface TenGigE0/1/0/2.999
Establishes interface TenGigE0/1/0/2.999 as an AC of bridge domain named test-efp.
Step 21 Use the commit or end command.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
333
Implementing Multipoint Layer 2 Services
Bridging on Ethernet Flow Points: Example
To Next Page
Loading...
Need help?
General
