Configuring an L2VPN Quality of Service Policy in VLAN Mode 110
Configuring Multisegment Pseudowire 111
Provisioning a Multisegment Pseudowire Configuration 111
Provisioning a Global Multisegment Pseudowire Description 113
Provisioning a Cross-Connect Description 114
Provisioning Switching Point TLV Security 116
Enabling Multisegment Pseudowires 117
Configuring Pseudowire Redundancy 118
Configuring Point-to-Point Pseudowire Redundancy 118
Forcing a Manual Switchover to the Backup Pseudowire 121
Configuring a Backup Pseudowire 121
Configuring Point-to-Point Pseudowire Redundancy 122
Forcing a Manual Switchover to the Backup Pseudowire 125
Configuring Preferred Tunnel Path 125
Configuring PW Status OAM 126
Enabling Flow-based Load Balancing 127
Enabling Flow-based Load Balancing for a Pseudowire Class 129
Enabling Pseudowire Grouping 130
Setting Up Your Multicast Connections 131
Configuring AToM IP Interworking 133
Configuring PPP IP Interworking 134
Configuring IP Interworking between PPP and Ethernet 137
Configuring MLPPP IP Interworking 140
Configuring Circuit Emulation Over Packet Switched Network 143
Adding CEM attachment circuit to a Pseudowire 143
Associating a Pseudowire Class 144
Enabling Pseudowire Status 147
Configuring a Backup Pseudowire 147
Configuring L2VPN Nonstop Routing 149
Configure MPLS LDP Nonstop Routing 150
Configuring L2TPv3 over IPv6 Tunnels 151
Configuring Neighbor AFI for Pseudowire 151
Configuring L2TPv3 encapsulation and protocol 153
Configuring Source IPv6 address for L2TPv3 over IPv6 tunnel 154
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
viii
Contents
To Next Page
Loading...
Need help?
General
