Configuring Local and Remote Sessions 156
Configuring Local And Remote Cookies 158
Enabling L2TP Static Submode 160
Enabling TOS Reflection in the L2TPv3 Header 161
Configuring TTL for L2TPv3 over IPv6 Tunnels 163
Configuring Traffic Mirroring over L2TPv3 over IPv6 Tunnels 164
Configuring L2TPv3 over IPv4 Tunnels 166
Configuring a Dynamic L2TPv3 Pseudowire 167
Configuring L2TPv3 Encapsulation and Protocol 168
Configuring L2TP Control-Channel Parameters 169
Configuring L2VPN Single Segment Pseudowire 172
Configuring L2VPN Global Parameters 172
Configuring L2VPN VPWS SS-PW 174
Configuring L2VPN MS-PW Address Family Under BGP 176
Verifying Single-Segment Pseudowires 177
Displaying Information about the L2VPN Single-Segment Pseudowires 177
How to Configure EPVN-VPWS 177
Configuring L2VPN EVPN Address Family Under BGP 177
Configuring EVPN-VPWS 178
Configuring an Access Pseudowire using EVPN-VPWS 180
Configuration Examples for Point to Point Layer 2 Services 181
L2VPN Interface Configuration: Example 182
Local Switching Configuration: Example 182
Local Connection Redundancy Configuration: Example 182
Point-to-Point Cross-connect Configuration: Examples 183
Inter-AS: Example 183
L2VPN Quality of Service: Example 185
Pseudowires: Examples 185
Configuring Dynamic Pseudowires at T-PE1 Node: Example 186
Configuring Dynamic Pseudowires at S-PE1 Node: Example 186
Configuring Dynamic Pseudowires at T-PE2 Node: Example 186
Configuring Dynamic Pseudowires and Preferred Paths at T-PE1 Node: Example 187
Configuring Dynamic Pseudowires and Preferred Paths at S-PE1 Node: Example 187
Configuring Dynamic Pseudowires and Preferred Paths at T-PE2 Node: Example 187
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
ix
Contents
To Next Page
Loading...
Need help?
General
