Wireless LAN Setup in Cisco Unified Communications Manager Administration
In Cisco Unified Communications Manager Administration, you must enable a parameter called “Wi-Fi” for
the wireless Cisco Desktop Collaboration Experience. You can enable this parameter in one of the following
locations in Cisco Unified Communications Manager Administration:
•
To enable wireless LAN on a specific phone, select the enable setting for the Wi-Fi parameter in the
Product Specific Configuration Layout section (Device > Phone) for the specific phone, and check the
Override Common Settings check box.
•
To enable wireless LAN for a group of phones, select the enable setting for the Wi-Fi parameter in a
Common Phone Profile Configuration window (Device > Device Settings > Common Phone Profile),
check the Override Common Settings check box, then associate the phone (Device > Phone) with that
common phone profile.
•
To enable wireless LAN for all WLAN-capable phones in your network, select the enable setting for
the Wi-Fi parameter in the Enterprise Phone Configuration window (System > Enterprise Phone
Configuration), and check the Override Common Settings check box.
In the Phone Configuration window in Cisco Unified Communications Manager Administration (Device
> Phone), use the wired-line MAC address when you configure the MAC address. Cisco Unified
Communications Manager registration does not use the wireless MAC address.
Note
Provision Wireless Profile
Procedure
Step 1
In Cisco Unified Communications Manager Administration, select Device > Phone > Wifi Profile.
Step 2
Configure the wireless profile and select Save.
Step 3
Select Device > Phone > Wifi Profile Group.
Step 4
Add the wireless profile to a wireless profile group and select Save.
Step 5
Select System > Device Pool.
Step 6
Add the wireless profile group to a device pool and select Save.
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
96
Wireless LAN Setup
To Next Page
Loading...
