5 GHz channel setAvailable channelsBand rangePart number
UNII-2
UNII-2
UNII-2 Extended
UNII-3
13 (14 in Japan)
4
4
11
4
2.412 – 2.484 GHz
5.180 – 5.240 GHz
5.260 – 5.320 GHz
5. 500 – 5.700 GHz
5.745 – 5.805 GHz
802.11j (channels 34, 38, 42, 46) and channel 165 are not supported.Note
Table 16: Supported Channels for Cisco Desktop Collaboration Experience DX600 Series
Channel SetAvailable
channels
Band rangePart number
1 - 13132.412 - 2.472 GHz-
36, 40, 44, 4845.180 - 5.240 GHz
52, 56, 60, 6445.260 - 5.320 GHz
100 - 140115. 500 - 5.700 GHz
149, 153, 157, 161, 16555.745 - 5.825 GHz
802.11j (channels 34, 38, 42, 46) are not supported.Note
World Mode (802.11d)
If you are using the Cisco Desktop Collaboration Experience DX600 series device in World mode, you must
enable World mode (802.11d). The Cisco Desktop Collaboration Experience DX600 series uses 802.11d to
determine which channels and transmit powers to use and inherits the client configuration from the associated
access point.
Enabling World mode (802.11d) may not be necessary if the frequency is 2.4GHz and the current access
point is transmitting on a channel 1-11.
Note
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
76
WLAN Standards and Technologies
To Next Page
Loading...
Need help?
General
