Adding a User to Cisco Unified Communications Manager
This section describes steps for adding a user to Cisco Unified Communications Manager. Follow one of the
procedures in this section, depending on your operating system and the manner in which you are adding the
user:
•
Adding a User From an External LDAP Directory, on page 196
•
Adding a User Directly to Cisco Unified Communications Manager, on page 196
Adding a User From an External LDAP Directory
If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you can
immediately synchronize that directory to the Cisco Unified Communications Manager on which you are
adding this same user and Cisco Desktop Collaboration Experience by following these steps:
Procedure
Step 1
Log onto Cisco Unified Communications Manager Administration.
Step 2
Choose System > LDAP > LDAP Directory.
Step 3
Use the Find button to locate your LDAP directory.
Step 4
Click on the LDAP directory name.
Step 5
Click Perform Full Sync Now.
If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified
Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP Directory
window determines when the next auto-synchronization is scheduled. However, the synchronization
must occur before you can associate a new user to a device.
Note
Step 6
Proceed to Identify Cisco Desktop Collaboration Experience Model, on page 197.
Adding a User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications Manager
Administration by following these steps:
If LDAP is synchronized, you cannot add a user to the Cisco Unified Communications Manager
Administration.
Note
Procedure
Step 1
Choose User Management > End User, then click Add New.
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
196
Adding a User to Cisco Unified Communications Manager
To Next Page
Loading...
