•
If you are configuring for Cisco Unified IP Phone failover configuration, enter the DNS alias of the
Cisco Unified IP Phone system.
Only Cisco Unified IP Phone is supported. Cisco Desktop Collaboration Experience Visual
Voicemail is not supported with Cisco Unified IP Phone.
Note
Step 4
Save changes and click Apply Config.
Step 5
Select Reset and Restart to deliver the new settings to the device.
Step 6
To allow secure messages on Cisco Desktop Collaboration Experience, from Cisco Unified IP Phone
Administration, choose System Settings > Advanced API Configuration and enable both Allow Access to
Secure Message Recordings through CUMI and Allow Message Attachments through CUMI.
Step 7
To configure Cisco Unified Communications Manager so that directory photos are configured in Cisco Desktop
Collaboration Experience Visual Voice Mail, choose Device > Device Settings > Common Phone Profile,
select a Common Phone Profile, and enter the URL for your organization’s photo directory in the Company
Photo Directory Field.
For more information about configuring and synchronizing Visual Voicemail, see the Voice-Mail Profile
Configuration chapter of the Cisco Unified Communications Manager Administration Guide. For information
on setting up a voicemail account, see the Cisco Desktop Collaboration Experience DX600 Series User Guide.
Set Up Web Proxy
This feature allows the user to enable and configure Web Proxy. Web Proxy can be enabled or disabled on
Cisco Desktop Collaboration Experience and configured either manually or by specifying proxy
auto-configuration (PAC) files. Using existing wired (Ethernet) and wireless (Wi-Fi) interfaces, you can add
new proxy configuration and view, modify, or delete existing proxy configurations.
Use this procedure to add Web Proxy on Cisco Desktop Collaboration Experience.
Procedure
Step 1
From the home screen, choose Settings > Ethernet > Proxy settings.
Step 2
Enter Type of proxy from drop-down list: Manual, or Auto.
•
For Manual proxy without authentication, choose Manual from Network type and enter Host name and
Port. (Do not tap Authentication.) Tap Save.
•
For Manual proxy with authentication, choose Manual from Network type and enter Host name and
Port. Tap Authentication and then enter User name and Password. Tap Save.
For details on supported authentication methods, see Authentication Methods, on page
86.
Note
To enable an existing proxy, choose Settings > Ethernet > Proxy settings and tap Proxy.
If VPN is enabled, no proxy will be configured or used for
VPN.
Note
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
138
Configure Product-Specific Options
To Next Page
Loading...
Need help?
General
