Wired Headsets
You can use the wired headset with all of the features on the Cisco Desktop Collaboration Experience phone,
including the Volume and Mute buttons. Use these buttons to adjust the earpiece volume and to mute the
speech path from the headset microphone.
Cisco Desktop Collaboration Experience supports 3.5 mm single plug headsets. To connect a wired headset
to Cisco Desktop Collaboration Experience, plug it in to the headset port to place and answer calls using the
headset.
If the headset is analog, see the for the procedure on configuring the wideband codec.
Related Topics
Analog Headsets, on page 54
Connect to Wired Headset
To connect a wired headset to the Cisco Desktop Collaboration Experience phone, perform these steps.
Procedure
Step 1
Plug the headset into the Headset port on the back of the phone.
Step 2
Press the Headset button on the phone to place and answer calls using the headset.
Disable Wired Headset
You can disable the headset by using Cisco Unified Communications Manager Administration. If you do so,
you also disable the speakerphone.
Procedure
Step 1
To disable the headset from Cisco Unified Communications Manager Administration, choose Device > Phone
and locate the phone that you want to modify.
Step 2
In the Phone Configuration window (Product Specific Configuration layout portion), check the Disable
Speakerphone and Headset check box.
USB Headsets
Wired and wireless USB headsets are supported. You can connect a USB headset (or the base station for a
wireless headset) to the side USB port.
Related Topics
Wireless Headsets, on page 54
Enable USB Headset
You must enable the applicable USB port (either the back USB port parameter or the side USB port parameter)
in Cisco Unified Communications Manager Administration (in the Product Specific Configuration layout
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
53
Cisco Desktop Collaboration Experience Phone Components
To Next Page
Loading...
