Cisco DX650 Administration Guide

Reset Debugging Log Profile to Default
Procedure
Step 1
Go to the Product Specific Configuration Layout section of the Individual phone configuration page or Common
Phone Profile page.
Step 2
Check Log Profile, and select Telephony from the drop-down menu list.
Step 3
Select Default from the drop-down menu list to reset all debugs back to the default values. This includes
debugs that have been set manually from Android Debug Bridge.
Step 4
Save and apply your changes.
Step 5
Select Preset from the drop-down menu list to keep the current debug levels.
Step 6
Save your changes.
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
206
Debugging Log Profiles

Cisco DX650 Specifications

General

Resolution	800 x 480 pixels
Audio	Wideband audio
USB Ports	2 x USB 2.0
Display	7-inch capacitive touchscreen
Camera	HD 720p
Connectivity	Ethernet, Wi-Fi
Bluetooth	Yes
SIP Protocol	Supported
Speakerphone	Full-duplex
Headset Jack	3.5 mm
Network Interfaces	10/100/1000 Ethernet
Supported Protocols	SIP
Codecs	G.722
Power over Ethernet (PoE)	Yes, IEEE 802.3af
Weight	2.2 lbs