Cisco DX650 - CHAPTER 4 Cisco Desktop Collaboration Experience Installation; Network Requirements

CHAPTER 4
Cisco Desktop Collaboration Experience
Installation
•
Network Requirements, page 47
•
Cisco Unified Communications Manager, page 48
•
Cisco Desktop Collaboration Experience Phone Components, page 48
•
Install Cisco Desktop Collaboration Experience, page 59
•
Phone Startup Verification, page 67
•
Network Settings, page 67
•
Cisco Desktop Collaboration Experience Phone Security, page 68
Network Requirements
Before you install a Cisco Desktop Collaboration Experience phone, you must decide how to configure
the phone in your network. Then you can install the phone and verify functionality. For more information,
see Cisco Desktop Collaboration Experience and Your Network, on page 31.
Note
For the Cisco Desktop Collaboration Experience phone to successfully operate as an endpoint in your network,
your network must meet the following requirements:
•
VoIP Network
◦
VoIP is configured on your Cisco routers and gateways.
◦
Cisco Unified Communications Manager is installed in your network and is configured to handle
call processing.
•
IP network that supports DHCP or manual assignment of IP address, gateway, and subnet mask
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
47