Cisco DX650 Administration Guide

Feature Control Policy Default Values
The following table shows the list of features that you can configure, and the default value.
Table 33: Feature Control Policy Default Values
Default valueFeature
EnabledBarge
EnabledCall Back
EnabledConference List
DisabledDivert (Alerting)
DisabledDivert (Connected)
EnabledForward All
DisabledMobility
DisabledPark
EnabledRedial
DisabledReport Caller
DisabledReport Quality
EnabledSpeed Dial
For more information, see the Feature Control Policy Configuration chapter in the Cisco Unified
Communications Manager Administration Guide.
Reset Options and Load Upgrades
Cisco Desktop Collaboration Experience receives configuration changes and load upgrades from Cisco Unified
Communications Manager. Cisco Desktop Collaboration Experience handles request changes by the following:
•
Reset will wait for active call to end.
•
If the device screen is on, user receives a popup dialog box that notifies the user about the changes and
the need for restart. The dialog box provides the following options:
◦
Restart: Dismisses the popup dialog box and restarts the device (default action).
◦
Snooze: Dismisses the popup dialog box for an hour. The user can set the device to snooze for a
maximum of 24 hours, after which the device will restart.
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
148
Feature Control Policy Default Values

Cisco DX650 Specifications

General

Resolution	800 x 480 pixels
Audio	Wideband audio
USB Ports	2 x USB 2.0
Display	7-inch capacitive touchscreen
Camera	HD 720p
Connectivity	Ethernet, Wi-Fi
Bluetooth	Yes
SIP Protocol	Supported
Speakerphone	Full-duplex
Headset Jack	3.5 mm
Network Interfaces	10/100/1000 Ethernet
Supported Protocols	SIP
Codecs	G.722
Power over Ethernet (PoE)	Yes, IEEE 802.3af
Weight	2.2 lbs