Procedure
Step 1
From Cisco Unified Communications Manager Administration, choose User Management > End User.
Step 2
Click Add New.
Step 3
Enter required User Information.
Step 4
In the Device Information window, select the device that you want to associate the user with.
Step 5
Click Save.
Step 6
In the Permissions Information window, assign the user Cisco Unified Communications Manager
Administration permissions.
Step 7
In the Permissions Information window, select Standard CCM End Users.
Step 8
Click Save and Apply Config. After the device reregisters, the user is configured to the device.
For information about resetting the PIN/password on Cisco Desktop Collaboration Experience, see the
following:
•
Reset Lost PIN or Password, on page 112
•
Cisco Desktop Collaboration Experience DX600 Series User Guide
Extension Mobility
Extension mobility is a phone feature that allows a user to log in to a device and access their own user extension
to make and receive calls from any device that is configured for extension mobility.
After extension mobility is turned on for a Cisco DX600 Series phone, the phone user sees a new option,
Extension Mobility, on the device at Settings > Personal > Extension Mobility. From the Lock screen, the
user sees the "Sign in as New User / Sign out" softkey if a user is currently logged in to this device.
To log in to a device, the user enters extension mobility credentials that the administrator supplies. These
credentials differ from the user Screen Lock PIN.
Note
The user sees these options on the phone Extension Mobility screen:
DescriptionSetting
The user ID of the user that is currently logged in to this phone.User ID
Tap this setting to change your extension mobility PIN. (Not all Cisco Unified
Communications Manager versions support this setting.) Remember that this is
the user extension mobility PIN, not the user Screen Lock PIN.
Set PIN
Tap this setting to delete all content and settings for this user from this device.Remove Account
Tap to sign out from this device. The device asks for sign-out confirmation; if the
user confirms sign-out, the device goes through reboot in order to return to the
device default settings.
SIGN OUT
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
140
Configure Product-Specific Options
To Next Page
Loading...
Need help?
General
