Cisco DX650 Administration Guide

Install Bracket
Follow this procedure to install the phone on the wall.
Procedure
Step 1
Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can
run the Ethernet network cable to a nearby jack.
a) Use the level to ensure that the bracket is level, then use a pencil to mark the screw holes.
b) Carefully center the anchor over the pencil mark and use a no. 2 Phillips screwdriver to press the anchor
into the wall.
c) Screw the anchor clockwise into the wall until the anchor is seated flush.
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
62
Install Cisco Desktop Collaboration Experience

Cisco DX650 Specifications

General

Resolution	800 x 480 pixels
Audio	Wideband audio
USB Ports	2 x USB 2.0
Display	7-inch capacitive touchscreen
Camera	HD 720p
Connectivity	Ethernet, Wi-Fi
Bluetooth	Yes
SIP Protocol	Supported
Speakerphone	Full-duplex
Headset Jack	3.5 mm
Network Interfaces	10/100/1000 Ethernet
Supported Protocols	SIP
Codecs	G.722
Power over Ethernet (PoE)	Yes, IEEE 802.3af
Weight	2.2 lbs