Configuring Regional Parameters and Supplementary Services
Scripting for Cadences, Call Progress Tones, and Ring Tones
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 195
7
• Number of Segments = 4
• Segment 1: On=0.38s, Off=0s, with Frequency 1
• Segment 2: On=0.38s, Off=0s, with Frequency 2
• Segment 3: On=0.38s, Off=0s, with Frequency 3
• Segment 4: On=0s, Off=4s, with no frequency components
• Total Tone Length = 20s
Ring Script
A RingScript is a mini-script that describes a ring tone. Syntax:
n=ring-tone-name;w=waveform-id-or-path;c=cadence-
id;b=break-time;t=total-time
ring-tone-name identifies this ring tone. This name appears on the Ring
Tone menu of the phone. The same name can be used in a SIP Alert-Info
header in an inbound INVITE request to tell the phone to play the
corresponding ring tone. The name should contain the same characters
allowed in a URL only.
waveform-id-or-path is the index of the desired waveform to use in this
ring tone. The built-in waveforms are:
- 1 = Classic phone with mechanical bell
- 2 = Typical phone ring
- 3 = Classic ring tone
- 4 = Wide-band frequency sweep signal
This field can also be a network path (url) to download a ring tone data file
from a server on-the-fly. In this case, the syntax of the field is:
w=[tftp://]hostname[:port]/path
cadence-id is the index of the desired cadence to play the given
waveform. 8 cadences (1–8) as defined in <Cadence 1> through <Cadence
8>. Cadence-id can be 0 If w=3,4, or an url. Setting c=0 implies the on-time
is the natural length of the ring tone file.
break-time specifies the number of seconds to break between two
bursts of ring tone, such as b=2.5.
To Next Page
Loading...
Need help?
General
