Getting Started
Using the Web-Based Configuration Utility
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 22
1
STEP 4 Browse to select the firmware file from your PC. Click Submit. The firmware is
installed and your phone reboots.
Cisco WIP310
STEP 1 Turn off your Cisco WIP310 and connect it to your computer by using a USB cable.
STEP 2 Double-click the executable file for the firmware upgrade (for example, double-
click wip310-5-0-11.exe).
STEP 3 Follow the on-screen instructions.
STEP 4 When the upgrade is complete, disconnect the phone from your PC and power it
on.
Using the Web-Based Configuration Utility
Your phone system administrator can allow you to view the phone statistics and
modify some or all of the parameters by using the phone web user interface. The
features of the Cisco SPA phones that can be modified by the user by using the
phone web user interfaceare described in this document; however, not all features
are available on all phones.
If you are using the Cisco SPA IP phones with the Cisco Unified Communications
500 Series for Small Business for Call Control, use Cisco Unified Communication
Manager Express or Cisco Configuration Assistant (CCA) for phone administration.
For more information, refer to the
Cisco Unified Communications 500 Office
Administrator Guide
or the
Cisco Configuration Assistant Smart Business
Communications System Administrator Guide
.
To access the IP phone configuration utility, launch a web browser on a computer
that can reach the phone on the subnetwork and enter the IP address of the phone
in your web browser address bar. For example, http://192.168.1.8. To get
the IP address of your phone, see Determining the IP Address of the Phone. If
you are connected to a VPN, you must first exit the VPN.
NOTE If your service provider disabled access to the configuration utility, you must
contact the service provider to proceed.
To Next Page
Loading...
Need help?
General
