Provisioning
Updating Profiles and Firmware
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 185
6
Launch a Firmware Update by using a Browser Command
An upgrade command entered into the browser address bar can be used to
upgrade firmware on a phone. The phone updates only when it is idle. The update
is attempted automatically after the call is complete.
To update the phone firmware, enter this command:
http://phone-ip-address/admin/upgrade?protocol://server-
name[:port]]/firmware-path
• protocol defaults to TFTP.
• server-name defaults to the host requesting the URL.
• port defaults to:
- 69 for TFTP
- 80 for HTTP
- 443 for HTTPS
• firmware-path defaults to /spa.bin (The firmware-pathname typically
includes the file name of the binary located in a directory on the TFTP or
HTTP server. For example, http://192.168.2.217/admin/
upgrade?tftp://192.168.2.251/spa.bin) for SPA phones, and
/wip310.img for the Cisco WIP310.)
Launch a Profile Update by using a Browser Command
Cisco SPA IP phones can synchronize to specific profiles stored on a remote
server. The phone resyncs only when it is idle. The update is attempted
automatically after the call is complete.
To update the phone profile, enter this command:
http://phone-ip-addr/admin/resync?protocol://server-
name[:port]/profile-pathname
• phone-ip-addr is the IP address of the phone.
• Parameter following resync? defaults to the Profile Rule setting on the
web server Provisioning page.
• protocol defaults to TFTP.
• server-name defaults to the host requesting the URL.
To Next Page
Loading...
Need help?
General
