Cisco SPA IP Phone Field Reference
SIP Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 271
A
Send Resp To Src Port Sends responses to the request source port
instead of the VIA sent-by port. Select yes or no
from the drop-down menu.
Defaults to no.
STUN Enable Enables the use of STUN to discover NAT
mapping. Select yes or no from the drop-down
menu.
Defaults to no.
STUN Test Enable If the STUN Enable feature is enabled and a valid
STUN server is available, the SPA9000 can
perform a NAT-type discovery operation when it
powers on. It contacts the configured STUN
server, and the result of the discovery is reported
in a Warning header in all subsequent REGISTER
requests. If the SPA9000 detects symmetric NAT
or a symmetric firewall, NAT mapping is disabled.
Defaults to no.
STUN Server IP address or fully-qualified domain name of the
STUN server to contact for NAT mapping
discovery. You can use a public STUN server or
set up your own STUN server.
EXT IP External IP address to substitute for the actual IP
address of the SPA9000 in all outgoing SIP
messages. If 0.0.0.0 is specified, no IP address
substitution is performed.
If this parameter is specified, the SPA9000
assumes this IP address when generating SIP
messages and SDP (if NAT Mapping is enabled
for that line). However, the results of STUN and
VIA received parameter processing, if available,
supersede this statically configured value.
Defaults to blank.
Parameter Description
To Next Page
Loading...
Need help?
General
