Cisco SPA301 User Manual

Cisco SPA IP Phone Field Reference
Phone Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 318
A
LDAP Display Attrs Format of LDAP results display on phone where:
• a—Attribute name
• cn—Common name
• sn—Surname (last name)
• telephoneNumber—Phone number
• n—Display name
For example, n=Phone causes "Phone:" to be displayed
in front of the phone number of an LDAP query result
when the detail soft button is pressed.
• t—type
When t=p, that is, t is of type phone number, then the
retrieved number can be dialed. Only one number can
be made dialable. If two numbers are defined as
dialable, only the first number is used. For example,
a=ipPhone, t=p; a=mobile, t=p;
This example results in only the IP Phone number
being dialable and the mobile number will be ignored.
• p—phone number
When p is assigned to a type attribute, example t=p,
then the retrieved number is dialable by the phone.
LDAP Number
Mapping
Can be blank if not needed.
NOTE With the LDAP number mapping you can manipulate
the number that was retrieved from the LDAP server. For
example, you can append 9 to the number if your dial plan
requires a user to enter 9 before dialing. Add the 9 prefix by
adding (<:9xx.>) to the LDAP Number Mapping field. For
example, 555 1212 would become 9555 1212.
If you do not manipulate the number in this fashion, a
user can use the Edit Dial feature to edit the number
before dialing out.
Parameter Description

Cisco SPA301 Specifications

General

Brand	Cisco
Model	SPA301
Category	IP Phone
Language	English