Cisco SPA301 User Manual

Getting Started
Using IVR on IP Phones Without Screens
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 32
1
220 Recites the method of call control (SIP or SPCP).
221 Set call control—enter the value for the call control method and press #:
•0: SIP
•1: SPCP
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
73738 Restores the phone to the factory default software and settings.
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
87778
(Cisco
SPA501G)
Restore the phone user settings to the default. (Clears all user settings
such as speed dials.)
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
732668 Reboot the phone. Enter # and hang up to begin rebooting.
111 Set a static IP address. Enter the IP address (use * to enter the decimal
(.)), then press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
121 Set a netmask. Enter the address (use * to enter the decimal (.)), then
press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
131 Set a gateway. Enter the address (use * to enter the decimal (.)), then
press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE DHCP must be disabled to use this option; if DHCP is not
disabled, you receive an error message.
161 Set the address of the primary Domain Name Server (DNS). Enter the
address (use * to enter the decimal (.)), then press #.
To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
Number Option

Cisco SPA301 Specifications

General

Brand	Cisco
Model	SPA301
Category	IP Phone
Language	English