Customizing Standard Features
Configuring Ring Tones
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 79
3
To configure ring tones:
STEP 1 Click Admin Login > advanced > Voice > Phone and scroll to the Ring Tone
section.
Configure the characteristics of each ring tone by using a Ring Tone script.
Specify:
• Name (n)—Ring tone name, such as Classic, Simple, or Office
• Waveform (w):
- (Not supported on the Cisco SPA300 Series or Cisco SPA5XXG.)
- (Cisco SPA525G or Cisco SPA525G2) 1, 2, 3, 4, file://Pulse1.raw, file://
Ring7.raw, file://Warble.raw, w=file://Low.raw, file://Floor.raw, file://
Reverb.raw
• Cadence (c)—1, 2, 3, 4, or 5 (Not supported on the Cisco SPA300 Series or
Cisco SPA5XXG.)
STEP 2 Click Submit All Changes.
You can also configure four additional ring tones to replace up to four of the
standard default ring tones. The following user-configurable ring tones are
available:
To configure/provision these ringtones:
STEP 1 Click Admin Login > advanced > Voice > Phone and scroll to the Ring Tone
section.
STEP 2 In the Ring Tone section, modify the n and w parameters in four of the 12 ring fields
(Ring1 to Ring12). Set the n parameter to the label of the ringtone you want
GUI Label Value of the w Parameter
Warble w=7
Low w=8
Floor w=9
Reverb w=10
To Next Page
Loading...
