D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
112
Cisco TelePresence SX80 Administrator Guide
Logging settings
Logging External Mode
Determine whether or not to use a remote syslog server for logging.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Disable logging to a remote syslog server.
On: Enable logging to a remote syslog server.
Logging External Protocol
Determine which protocol to use toward the remote logging server. You can use either the
syslog protocol over TLS (Transport Layer Security), or the syslog protocol in plaintext. For
details about the syslog protocol, see RFC 5424.
Requires user role: ADMIN
Default value: SyslogTLS
Value space: Syslog/SyslogTLS
Syslog: Syslog protocol in plain text.
SyslogTLS: Syslog protocol over TLS.
Logging External Server Address
The address of the remote syslog server.
Requires user role: ADMIN
Default value: ""
Value space: String (0..255)
A valid IPv4 address, IPv6 address or DNS name.
Logging External Server Port
The port that the remote syslog server listens for messages on. If set to 0, which is the
default, the video system will use the standard syslog port. The standard syslog port is 514
for syslog, and 6514 for syslog over TLS.
Requires user role: ADMIN
Default value: 0
Value space: Integer (0..65535)
The number of the port that the remote syslog server is using. 0 means that the video
system uses the standard syslog port.
Logging Mode
Define the logging mode for the video system (syslog service). When disabled, the syslog
service does not start, and most of the event logs are not generated. The Historical Logs
and Call Logs are not affected.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Disable the system logging service.
On: Enable the system logging service.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
