D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
96
Cisco TelePresence SX80 Administrator Guide
Cameras settings
Cameras Camera [1..7] AssignedSerialNumber
The camera ID is the number n in Camera [n]. By default, the camera ID is assigned
automatically to a camera. If EDID information is not passed on from the camera to the
codec, the camera ID is not persistent after a reboot. This means that a camera may get a
new camera ID when the codec (video system) is restarted.
You should use the Cameras Camera AssignedSerialNumber setting to cater for
configurations where the codec does not receive EDID information from multiple cameras.
This setting allows you to manually assign a camera ID to a camera by associating the
camera ID with the camera's serial number. The setting is persistent until the codec is
factory reset.
Typical situations where the codec does not receive EDID information are: when you
connect a Cisco TelePresence 60 camera using 3G-SDI; when you connect a Cisco
TelePresence 60 (Cisco PrecisionHD 1080p4xS2) camera; when you use an HDMI repeater
that does not pass on EDID information.
The default value is an empty string.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 20)
The camera's serial number.
Cameras Camera [1..7] Backlight DefaultMode
This configuration turns backlight compensation on or off. Backlight compensation is
useful when there is much light behind the persons in the room. Without compensation the
persons will easily appear very dark to the far end.
Requires user role: ADMIN, USER
Default value: Off
Value space: Off/On
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
Cameras Camera [1..7] Brightness Mode
Define the camera brightness mode.
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Manual
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set
using the Cameras Camera [n] Brightness DefaultLevel setting.
Cameras Camera [1..7] Brightness DefaultLevel
Define the brightness level. Requires the Cameras Camera [n] Brightness Mode to be set to
Manual.
Requires user role: ADMIN, USER
Default value: 20
Value space: Integer (1..31)
The brightness level.
Cameras Camera [1..7] Flip
With Flip mode (vertical flip) you can flip the image upside down. Flipping applies both to
the self-view and the video that is transmitted to the far end.
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Off/On
Auto: If the camera detects that it is mounted upside down, the image is automatically
flipped. If the camera cannot auto-detect whether it is mounted upside down or not, the
image is not changed.
Off: Display the image on screen the normal way.
On: Display the image flipped upside down. This setting is used when a camera is
mounted upside down, but cannot automatically detect which way it is mounted.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
