D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
19
Cisco TelePresence SX80 Administrator Guide
You can use the Shutdown button on the front panel to
switch the codec On and Off, provided that the Power
switch on the codec’s rear side is On.
• To switch Off the codec, hold the button until the
LEDs go out.
• To switch On the codec, hold the button until the
LEDs flash. It may take a few minutes for the codec
to start up. The system is ready for use when the
Power LED lights steadily.
The power switch on the codec’s rear side is its main
On/Off switch.
It may take a few minutes for the codec to start up. The
Power LED lights steadily when the system is ready for
use.
Power On and Off
Power On/Off with the Power switch or Shutdown button
Power
switch
Shutdown
button
Power Off or restart the system remotely
Sign in to the web interface and navigate to Maintenance >
Restart.
Restart the system
Click Restart device... and confirm your choice.
It takes a few minutes before the system is ready for use.
Power Off the system
Click Shutdown device... and confirm your choice.
You cannot power On the system remotely.
Restart and standby using the Touch
controller
Restart the system
1. Select the settings icon (cogwheel) in the status bar of
the Touch controller.
2. Select Settings > Restart.
3. Select Restart again to confirm your choice.
Enter/exit standby mode
1. Select the settings icon (cogwheel) in the status bar of
the Touch controller.
2. Select Standby.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
