D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
51
Cisco TelePresence SX80 Administrator Guide
Sign in to the web interface and navigate to Setup > Configuration,
to find the settings referred.
Use the Cameras > SpeakerTrack > Mode setting to enable or
disable speaker tracking.
Off: Speaker tracking is switched off permanently.
Auto: Speaker tracking is enabled in general. Users can
switch it on or off instantly in the camera control panel on the
Touch controller.
Set up the SpeakerTrack feature
About speaker tracking
The following Cisco TelePresence
products support speaker tracking:
• MX700 and MX800 with dual camera
• SpeakerTrack 60 camera
The two cameras in the assembly work
together with a built-in microphone array
to automatically track and show the
person that speaks.
Tracking mode
The tracking mode defines how fast the camera view switch to a
new speaker when the tracking algorithm detects a change.
Use the Cameras > SpeakerTrack > TrackingMode setting to
select between the two modes.
Auto: This is the default setting.
Conservative: The system reacts slower to detected changes,
and the camera view will switch to a new speaker later.
You can also use the Administrator Settings menu on the
Touch controller to switch between the two tracking modes.
• Tap Settings > Administrator and sign in.
• Tap Tracking, and set Tracking Mode to NORMAL (auto) or
CONSERVATIVE.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
