D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
50
Cisco TelePresence SX80 Administrator Guide
Connect input sources (page 2 of 2)
About video and content quality
Use the Video > Input > Connector n > Quality setting to optimize
quality with respect to motion or sharpness.
Typically, you should choose Motion when a large number of
participants are present or when there is a lot of motion in the
picture. Choose Sharpness when you want the highest quality of
detailed images and graphics.
The default value is Motion for Connector 1, 2 and 5; and
Sharpness for Connector 3 and 4.
Set type and name for the input sources
We recommend that you set type and name for the input sources:
• Video > Input > Connector n > InputSourceType
• Video > Input > Connector n > Name
These settings determine the names and icons that are shown
on the user interfaces. Intuitive names and icons make source
selection easier.
To Next Page
Loading...
