Cisco TelePresence SX80 Administrator's Guide

D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
120
Cisco TelePresence SX80 Administrator Guide
NetworkServices settings
NetworkServices CDP Mode
Enable or disable the CDP (Cisco Discovery Protocol) daemon. Enabling CDP will make the
endpoint report certain statistics and device identifiers to a CDP-enabled switch. If CDP is
disabled, the Network VLAN Voice Mode: Auto setting will not work.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The CDP daemon is disabled.
On: The CDP daemon is enabled.
NetworkServices H323 Mode
Define whether the system should be able to place and receive H.323 calls or not.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Disable the possibility to place and receive H.323 calls.
On: Enable the possibility to place and receive H.323 calls (default).
NetworkServices HTTP Mode
Define whether or not to allow access to the video system using the HTTP or HTTPS (HTTP
Secure) protocols. Note that the video system's web interface use HTTP or HTTPS. If this
setting is switched Off, you cannot use the web interface.
If you need extra security (encryption and decryption of requests, and pages that are
returned by the web server), allow only HTTPS.
Requires user role: ADMIN
Default value: HTTP+HTTPS
Value space: Off/HTTP+HTTPS/HTTPS
Off: Access to the video system not allowed via HTTP or HTTPS.
HTTP+HTTPS: Access to the video system allowed via both HTTP and HTTPS.
HTTPS: Access to the video system allowed via HTTPS, but not via HTTP.
NetworkServices HTTPS VerifyServerCertificate
When the video system connects to an external HTTPS server (like a phone book server
or an external manager), this server will present a certificate to the video system to identify
itself.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Do not verify server certificates.
On: Requires the system to verify that the server certificate is signed by a trusted
Certificate Authority (CA). This requires that a list of trusted CAs are uploaded to the
system in advance.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings

Cisco TelePresence SX80 Specifications

General

Maximum frame rate	60 fps
Supported video modes	720p, 1080p
Video formats supported	H.261, H.262, H.263, H.264, H.265
Supported graphics resolutions	1280 x 720 (HD 720), 1920 x 1080 (HD 1080)
Voice codecs	G.711, G.722, G.722.1, G.729ab
Noise reduction	Yes
HDMI ports quantity	5
DVI-D ports quantity	1
USB 2.0 ports quantity	2
Product color	Silver
Rack capacity	1U
Number of persons	0 person(s)
Analog signal format system	NTSC, PAL
Security algorithms	HTTPS, SSH
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Supported network protocols	SIP, H.323, ISDN, TCP/IP, DHCP, QoS
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Sensor type	-
Image sensor size	- \

Weight and Dimensions

Depth	309.8 mm
Width	442 mm
Height	44 mm
Weight	3650 g