D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
97
Cisco TelePresence SX80 Administrator Guide
Cameras Camera [1..7] Focus Mode
Define the camera focus mode.
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Manual
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the
right focus; then auto focus is turned off to prevent continuous focus adjustments of the
camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Cameras Camera [1..7] Gamma Mode
This setting enables gamma corrections, and applies only to cameras which support
gamma mode. Gamma describes the nonlinear relationship between image pixels and
monitor brightness.
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Manual
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref.
Cameras Camera [n] Gamma Level.
Cameras Camera [1..7] Gamma Level
By setting the Gamma Level you can select which gamma correction table to use. This
setting may be useful in difficult lighting conditions, where changes to the brightness setting
does not provide satisfactory results. Requires the Cameras Camera [n] Gamma Mode to be
set to Manual.
Requires user role: ADMIN, USER
Default value: 0
Value space: Integer (0..7)
Define the gamma level.
Cameras Camera [1..7] Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen. Mirroring applies
both to the self-view and the video that is transmitted to the far end
Requires user role: ADMIN, USER
Default value: Auto
Value space: Auto/Off/On
Auto: If the camera detects that it is mounted upside down, the image is automatically
mirrored. If the camera cannot auto-detect whether it is mounted upside down or not,
the image is not changed.
Off: Display the image as other people see you.
On: Display the image as you see yourself in a mirror.
Cameras Camera [1..7] MotorMoveDetection
This setting applies only when using a Cisco TelePresence PrecisionHD 1080p12x camera.
If adjusting the camera position by hand you can configure whether the camera should keep
its new position or return to the preset or position it had before.
Requires user role: ADMIN, USER
Default value: Off
Value space: Off/On
Off: When the camera position is adjusted manually the camera will keep this position
until adjusted again. WARNING: If moving the camera by hand, the camera will not
register the new pan and tilt values since there is no position feedback. This will result in
wrong pan and tilt values when recalling the camera presets subsequently.
On: When the camera position is adjusted manually, or the camera detects that the
motors have moved, it will first re-initialize (i.e. go to default position) then return to the
preset/position it had before the camera was adjusted.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
