Diagnostics and Troubleshooting 3-67
The System Configuration Utility setting should resemble the settings in Table 3-22 when you
enable ASR-2 to restart into the operating system:
Table 3-22
Operating System Restart SCU Setting for ASR-2
Option Setting
Serial interface COM1
Dial-In status Disabled
Dial-Out status Disabled
Dial-Out string 555-1234
Network status Disabled
Network protocol IPX
Network interface controller Compaq
Network host name CPQHOU
Network controller slot Slot #
Network frame type ETHERNET_II
Network IP address xxx.xxx.xxx.xxx
Network IP net mask xxx.xxx.xxx.xxx
Network IP router address xxx.xxx.xxx.xxx
ASR-2 Security
The standard Compaq password features function differently during ASR-2 than during a
typical system startup. During ASR-2, the system does not prompt for the power on password.
Not prompting a power on password allows ASR-2 to restart the operating system or Compaq
Utilities without user intervention.
To maintain system security, set the server to start in Network Server Mode (an option in the
System Configuration Utility). This option ensures that the server keyboard is locked until you
enter the keyboard password.
Select an administrator password (an option in the System Configuration Utility). During
attended ASR-2 (local or remote), you must enter this administrator password before any
modifications can be made to the server configuration.
To Next Page
Loading...
Need help?
General
